CAN-CBM-Bridge/2
₹0.00
Tax included
Intelligent CAN-Bridge
Features
Linking two CAN nets with data buffering
Different bit rates on the CAN nets possible
11-bit ID and 29-bit ID bridge
Internal microcontroller MB90F543
High-Speed CAN interface acc. to ISO 11898-2, 1 Mbit/s
Electrical isolation by optocouplers and DC/DC-converters
Configuration of the CAN-CBM-Bridge/2 module is easily done by means of a PC/terminal
Direct fixing at DIN-EN carrier rail mounting (TS 35)
Linking two CAN networks
The module CAN-CBM-Bridge/2 can link two independent CAN networks. The networks can be operated with different bit rates. The module operates with a MB90F543 microcontroller, which buffers the CAN data in a local SRAM. The firmware is in the flash. A serial EEPROM stores parameters.
CAN-Interface
The ISO 11898-compatible CAN interfaces allow each a maximum data-transfer rate of 1 Mbit/s. The CAN interfaces are electrically insulated by optocouplers and DC/DC converters. They are connected via 5-pin screw/plug connectors in Combicon design.
Programming
The RS-232 is used as serial programming interface. The interface is connected via a DSUB9 connector.
The CAN-CBM-Bridge/2 module can easily be configured by means of a terminal, e.g. Windows Hyperterminal.
The module is a 11-bit-ID and a 29-bit-ID Bridge. Up to 26 unidirectional links of identifiers can be configured. Beyond that up to four masks can be defined to link the identifiers completely or to link defined ranges of identifiers.
Specific References
On Top
