CANopen-DP
₹0.00
Tax included
PROFIBUS-DP®/CANopen® Gateway
Connection of CANopen Devices and Networks to PROFIBUS-DP
DP-slave with 240 bytes input and 240 bytes output PROFIBUS data
CANopen Manager
Cycle time only limited by PROFIBUS
Application example: SIEMENS SIMATIC-S7 to CANopen
PROFIBUS-DP slave according to IEC 61158
Configuration with Standard Tools
Run-time configuration via PLC
No special tools required
Plug 'n' play replacement
There is an alternative product. Please have a look at: CANopen-DP/2
Linking PROFIBUS-DP and CANopen
The module CANopen-DP can link any PROFIBUS-DP master to a CANopen network. The gateway operates as a PROFIBUS-DP slave-I/O component with a total of maximum 240 bytes input and 240 bytes output data. It supports cyclic (DP-V0) as well as acyclic (DP-V1) PROFIBUS data transfers. On CANopen it operates as a CANopen manager supporting CANopen master, NMT master and configuration functions. PDO and SDO (with SDO timeout and MPDO transmission) data transfers are supported. START frame, SYNC and Heartbeat are controlled by the module.
Applications
With the CANopen-DP gateway you can couple CANopen modules to e.g. a SIMATIC-S7. The number of CANopen devices is not limited by the module.
Physical Interfaces
The ISO 11898-compatible CAN interface allows a maximum data-transfer rate of 1 Mbit/s. The PROFIBUS-DP-Slave interface automatically recognizes all usual bit rates up to 12 Mbit/s. The PROFIBUS-DP as well as the CAN interface are electrically isolated.
Configuration and CAN protocols
The module can be configured via PROFIBUS configuration tool, e.g. the PLC SIMATIC Manager. CANopen is supported as CAN-layer-7 protocol on the CAN layer. Additionally CAN-layer-2 functions are available.
Specific References
On Top
