CANopen-DP/2
₹0.00
Tax included
Gateway CANopen® to PROFIBUS-DP® Slave
Connection of CANopen Devices and Networks to PROFIBUS-DP
PROFIBUS-DP slave acc. to IEC 61158 (240 bytes input and 240 bytes output)
CANopen Manager
Cycle time only limited by PROFIBUS-DP
Extendable with CANopen Modules via InRailBus
Cable-free connection of esd CAN-CBX I/O modules to the gateway
InRailBus for CAN connection and power feed
Configuration with Standard Tools
Run-time configuration via PLC
No special tools required
Plug 'n' play replacement
esd is a member of the PNO (PROFIBUS Nutzerorganisation e.V.)
Linking PROFIBUS-DP and CANopen
The CANopen-DP/2 can link any PROFIBUS-DP master to a CANopen network. The gateway operates as a PROFIBUS-DP slave-I/O component with a total of maximum 240 bytes input and 240 bytes output data. It supports cyclic (DP-V0) as well as acyclic (DP-V1) PROFIBUS data transfers. On the CANopen side it operates as a CANopen manager supporting NMT master and configuration functions. PDO and SDO (with SDO timeout and MPDO transmission) data transfers are supported. START frame, SYNC and Heartbeat are controlled by the module.
Applications
With the CANopen-DP/2 gateway you can couple CANopen modules e.g. to a SIMATIC-S7. The number of CANopen devices is not limited by the module.
Physical Interfaces
The ISO 11898-compatible CAN interface allows a maximum data-transfer rate of 1 Mbit/s. The PROFIBUS-DP-Slave interface automatically recognizes all usual bit rates up to 12 Mbit/s. The PROFIBUS-DP as well as the CAN interface are electrically isolated.
Configuration and CAN Protocols
The module can be configured via PROFIBUS configuration tool, e.g. the PLC SIMATIC Manager. CANopen is supported as CAN-layer-7 protocol on the CAN layer. Additionally CAN-layer-2 functions are available.
Specific References
On Top
